Made from High Strength Laser Cut T1 Steel. Will not flex or bend like normal mild steel, weld washers are not required, these are built from the highest grade steel on the market.
If you want to do your brackets once and not have to worry about replacement or repair in the future this is the Kit you want!
Width can be adjusted for different Heims. Contact for Custom Size Bolt Holes
This is for one Axle, comes with:
Top Plate (Front, Front Flipped, Or Rear)
Side Plates And Spacer Plate
2 Short Lower Link Mounts
2 Long Lower Link Mounts
4 Flat Mount Link Tabs
Bolts Required (Option to purchase bolt kit):
(6x) 1/2"x2" NC Bolt Gr 8
(8x) 3/8"x1.75" NC Bolt Gr 8
(4x) 3/8"x1" NC Bolt Gr 8
(6x) 1/2" Lock Washer
(12x) 3/8" Lock Washer
When installing the 2.5 Ton Top Hat, leave the diamond shaped side plate and rectangle top in place. Due to difference in manufacturing, the top may have to ground down a bit slightly in the area shown, in the spacer plate image.
A great setup for the lower 4 link mounts on your mega truck or buggy! Key together design makes for easy setup and welding, convenient clean out holes keep mud and dirt from building up around your heim joints, made from high tensile steel gives you the absolute maximum strength without adding excess weight!
Will mount to 2" and 1.75" OD tubing.
Designed to work with 1.25" Heim Joints with a 3/4" Bolt hole, 2.625" Mounting width
Made from High Strength Laser Cut T1 Steel. Will not flex or bend like normal mild steel, weld washers are not required, these are built from the highest grade steel on the market.Width can be adjusted for different Heims. Contact for Custom Size Bolt Holes
This is for one Axle, comes with:
Top Plate (Front, Front Flipped, Or Rear)
Side Plates And Spacer Plate
2 Short Lower Link Mounts
2 Long Lower Link Mounts
4 Flat Mount Link Tabs
Bolts Required (Option to purchase bolt kit):
(4x) 1/2"x2-1/2" NC Gr 8 Bolt
(10x) 3/8"x1-3/4" NC Bolt Gr 8
(8x) 3/8"x1-1/4" NC Bolt Gr 8
When installing the 5 Ton Top Hat, leave the diamond shaped side plate and rectangle top in place. Due to difference in manufacturing, the top may have to ground down a bit slightly in the area shown, in the spacer plate image.
Made from High Strength Laser Cut T1 Steel. Will not flex or bend like normal mild steel, weld washers are not required, these are built from the highest grade steel on the market, 12" of link separation is good for 50"+ tires, Width can be adjusted for different Heim spacing. Contact for Custom Size Bolt Holes,