SCS Gearbox


    If Drop Box/Chain Case and drive line is not installed by WCR or a qualified shop, there will be zero warranty on any malfunction.

    This includes but is not limited to;

    Failed bearings and cases,
    Drive shafts must be balanced, built and installed by WCR or a certified shop. Failed seals and bearings due to out of balance/ out of phase or binding drive line will not be covered under warranty.
    • When being married to turbo 400 t-case you will require a 1.5" long output shaft
    • To check your Transfer Case gear ratio, follow this link to SCS Calculator page 
    • The 12.66 and 10.66 shafts are a different spline, therefore if you are updating your case, make sure to order the correct output flanges for your case.

    13 products